PDA

View Full Version : 1995 Cherokee Crawler Long Arm'ed


MuddyPaws 3.0
09-06-2010, 06:57 PM
1995 Jeep Cherokee

4.0 High Output

AW4 Automatic Transmission

NP231 Transfer Case NP241 lower planets, wide chain kit, SYE, CV driveshafts

Front D30 4.56 gears, locker, CV alloy (lifetime warranty) axle shafts, lifetime unit bearings. Have a spare set of stock shafts I will include.

Rear Ford 8.8 4.56 Gears, locker, disk brakes, Riddler heavy duty diff cover

Lower half painted with Durabak bed liner.

BDS 6.5 inch long arm lift kit with spherical ends and transfer case skid plate

Rear boomerang shackles

BDS lower control arm skid plates

BSD Quick disconnect sway bar end links

Rancho RS9000 long travel adjustable shocks with in cab controller. Air compressor wired and mounted

2 inch alloy wheel spacers

Extended Stainless brake lines everywhere

Upgraded master cylinder

Wired for front rock lights but they are kinda broken

Full interior roll cage

Custom front winch bumper

Trailer hitch

Heavy gas tank skid plate

CB radio

Gran Am hood vents

New head liner

Rubber Jeep pad in cargo area

Full set (5) of 35x12.5 ProComp XTerrains 4 have about 70% tread and are grooved, spare has less than 100 miles on it. 5 matching Eagle Alloy 589 rims. Rock rash of different degrees on edges

Has a roof top spare tire carrier but the tire is not up there in some of these pictures.

Front fenders trimmed very high. Rear fenders cut very high and re-welded. This thing flexes like crazy. Has limit straps on front.

Full Pioneer stereo system. CD/MP3 deck with aux plug (DEH1900MP), (4) 6 inch 3 way door speakers, 1200 watt D1100M mono amp running a single 10 inch W2501D4 sub in custom box. Box was designed with storage units for soft gear like rain coats, tow straps, gloves etc. All stereo parts Pioneer Premier.

Superwinch EP 9.0 winch with Synthetic line. Has in-cab controller and WIRELESS controller. Control winch with a key fob size remote.

Wired for Garmin GPS. Magnetic high gain antenna and power connector wired in and come out above where the rear view mirror was.

I am sure I am missing something.

Pictures are located here: http://s588.photobucket.com/albums/ss321/timstrader/sale/jeep/

This is a wheelin rig that drives on the road just fine. It has been wheeled and is in no way perfect. Almost no rust but several dents. Surface rust on front bumper and rear bumper for the most part. No rust on body. Dents and dings, see the pics. Very capable rig. Selling because it's time for something different.

Needs tie rods and ball joints. Ball joints are lifetime warranty from Advance Auto. It's dirty and needs to be cleaned. Cleans up nice.

$5500 obo? The only trades I will consider include a no / low rust YJ with a 4.0 fuel injected motor and an automatic transmission + cash. No carbed motors or manual transmissions. Need not be running but must have all the parts. Also not concerned with axles or tire condition or the front fenders. May consider a trade for a rig with 60's already in it and 38's or bigger.

http://i588.photobucket.com/albums/ss321/timstrader/sale/jeep/IMGP1648.jpg

http://i35.photobucket.com/albums/d182/scottkillingbeck/Canada%20Jun%202010/DSCF4220.jpg

http://i35.photobucket.com/albums/d182/scottkillingbeck/Canada%20Jun%202010/DSCF4422.jpg

Beefy
09-06-2010, 08:16 PM
:woot: